Our email address is new, please update !

weekendframe@att.net

Updated Air Dam for use with our front mounted Fuel Cell

Here's the latest air dam for use with Weekend's front mounted 3.5 gallon Fuel Cell.

This part mounts from the bottom so there are no visible fasteners.

Call to order yours today!

PARACHUTE SYSTEM

As an added safety measure, many racers are planning on adding a parachute

system to their 200 MPH+ motorcycles. The photos below are of a chute system

 that I added to Steve Dorn's T/F bike. The entire system was a bolt on application.

The system , with the exception of the deployment button, stays with the wheelie bar.

 Simply remove the air line from the push to connect fitting and remove the wheelie bar

 as you normally would.

The chute pack launcher bolts to the X-bracing of the wheelie bar.

The air cylinder / cable is mounted to the left side of the wheelie bar.

The compact deployment button was easily mounted to the handlebar.

The crank that retracts the launcher spring is supported by the

launcher mounting bracket to prevent slipping off the winding nut.

Call John for more details  903-569-3555

HAND HELD STARTER

These high quality starters were specifically designed for starting high compression

          or large displacement gasoline powered engines like the NHRA V-Twin and metric drag bikes.

 The starter uses a 3/4" square drive that plugs into the crankshaft of the bike for starting.

It is also equipped with an overrun clutch to prevent damage to the starter motors when the engine fires.

$1295